Anyone know of a bottle cage with the bolt holes right at the bottom, so the cage essentially mounts very high up?

Cheers

I know of the little bar things that move cages up or down, these are the second best option

You could drill your own hole in the correct place, as long as there is some material to drill through?

Yup, happy to do so if I find a cage with a big enough base


I have also just found the wolf tooth morse cage... but its £40 for a bottle cage!!

King Cage do one in SS or Ti. I use the opposite version to lower rather than raise.

FLV wrote: ↑Thu Feb 22, 2024 12:11 pm Anyone know of a bottle cage with the bolt holes right at the bottom, so the cage essentially mounts very high up?

Cheers

I know of the little bar things that move cages up or down, these are the second best option

I found my Specialized Roll cage mounted low, and thus pushed the bottle quite high.

https://www.tradeinn.com/bikeinn/en/spe ... lsrc=aw.ds

Could always use a wolf tooth B Rad to adjust position upwards

Widefoot jist released their new StoutCage....

https://widefoot.com/product/stoutcage/

samwise wrote: ↑Thu Feb 22, 2024 9:12 pm Widefoot jist released their new StoutCage....

https://widefoot.com/product/stoutcage/

Does it hold a can of Guinness?

well played

Profile Design Kage has high and low mounting holes already

I just bought 2 of these but not used them yet. They have 3 bolt holes in them but aren't evenly spaced but the lowest is right at the bottom then 2x normal position. Also the silver bar doesn't move, its a plastic ring not rubber and it's only cheap elastic. The reviews seem positive though.

https://www.sjscycles.co.uk/bottles-cag ... ttle-cage/

Actually that plastic loop doesn't go over any bottle i've just tried and your generic high-5 bottle is too small to fit, its 1.5-2l bottles only