Fred Bar wanted
Moderators: Bearbonesnorm, Taylor, Chew
-
Margo plicatus
- Posts: 9
- Joined: Sun Feb 06, 2022 8:17 pm
Fred Bar wanted
If anyone has one clogging up their garage I’d like one please 
-
fatbikephil
- Posts: 6550
- Joined: Wed Apr 02, 2014 10:51 pm
- Location: Fife
- Contact:
Re: Fred Bar wanted
https://www.sjscycles.co.uk/accessories ... -mm-0-deg/
Dims are different but similar and much cheapness...
I use one as a lower bar roll support
Dims are different but similar and much cheapness...
I use one as a lower bar roll support
-
Margo plicatus
- Posts: 9
- Joined: Sun Feb 06, 2022 8:17 pm
Re: Fred Bar wanted
Want them for aero bars (not cos I’m aero 
, just want to stop getting ulnar nerve pain) what’s the verdict on whether these are “strong” enough?
, just want to stop getting ulnar nerve pain) what’s the verdict on whether these are “strong” enough?-
fatbikephil
- Posts: 6550
- Joined: Wed Apr 02, 2014 10:51 pm
- Location: Fife
- Contact:
Re: Fred Bar wanted
Well the wall thickness of the tubes is 3mm, the clamp bit heftier still; and the welds are nice and big so it would probably be fine....
I'd probably trust it for the arm rests so not sure if you could mount the forward extensions on the bars angled up and use this bracket for just the arm rests??
I'd probably trust it for the arm rests so not sure if you could mount the forward extensions on the bars angled up and use this bracket for just the arm rests??