Son28 hub spoke issues
Moderators: Bearbonesnorm, Taylor, Chew
Son28 hub spoke issues
So iv been reading on net about there being a few issues with these closing the gap between spokes and brake caliper on 160mm rotors? Anyone experience this ta
- Bearbonesnorm
- Posts: 23942
- Joined: Sun Jun 05, 2011 8:53 pm
- Location: my own little world
Re: Son28 hub spoke issues
Have a word with Shona Mike, they've lots of experience with SON so should know about any issues.
May the bridges you burn light your way
Re: Son28 hub spoke issues
Cheers stu
-
- Posts: 2380
- Joined: Thu Dec 15, 2016 7:52 pm
- Location: Peoples Republic of Devon
Re: Son28 hub spoke issues
Yes they do.
No problems on my road bike. BB5 and Spyre caliper worked on a Kinesis carbon fork with 160mm rotor.
On my Krampus the angle is tight but a BB7 fits - just with either 180 or 203mm rotor. Problem is compounded by very off centre spoke holes on a Fatlab 55 rim.
With a Love Mud Juice on the same bike and rim a Spyke caliper would not fit at all and a BB7 required a little love from a Dremel to get clearance.
On a 26er Thorn with Magura Odur fork there was bags of clearance.
No problems on my road bike. BB5 and Spyre caliper worked on a Kinesis carbon fork with 160mm rotor.
On my Krampus the angle is tight but a BB7 fits - just with either 180 or 203mm rotor. Problem is compounded by very off centre spoke holes on a Fatlab 55 rim.
With a Love Mud Juice on the same bike and rim a Spyke caliper would not fit at all and a BB7 required a little love from a Dremel to get clearance.
On a 26er Thorn with Magura Odur fork there was bags of clearance.
If you are going through hell, keep going.
WSC
WSC
Re: Son28 hub spoke issues
I had it with an SP hub. Solution is to space the disc away from the hub.
e.g. Hope 6 Bolt Hub Disc Spacer https://g.co/kgs/iuZJyZ
e.g. Hope 6 Bolt Hub Disc Spacer https://g.co/kgs/iuZJyZ
-
- Posts: 518
- Joined: Sun Mar 18, 2018 10:23 am
- Location: Sussex
Re: Son28 hub spoke issues
Plus one for the above solution, again with an sp hub, but I used m5 stainless washers to shim it.